Connections and Cabling Getting Started
page 2-4 OmniSwitch 6350 Hardware Users Guide September 2015
Connections and Cabling
Once your switch is properly installed, you should connect all network and management cables required for
your network applications. Connections may include:
• DB9-to-RJ-45 cable to the console connector
• Cables to 10/100/1000 Ethernet or SFP ports
Note. For additional information on cabling connections, refer to the OmniSwitch AOS Release 6 Switch
Management Guide.
Serial Connection to the Console Port
The console port provides a serial connection to the switch using a USB connector and is required when
logging into the switch for the first time. By default, this connector provides a DCE console connection.
Serial Connection Default Settings
For information on modifying these settings, refer to the OmniSwitch AOS Release 6 Switch
Management Guide.
baud rate 9600
parity none
data bits (word size) 8
stop bits 1
To Next Page
Loading...
