Mounting OmniSwitch 6450 Switches Rack-Mounting 24 and 48-Port OS6450 Switches
OmniSwitch 6450 Hardware Users Guide September 2015 page 4-11
Rack Mounting Steps
1 Attach rack mount brackets to both sides of the chassis as shown.
2 Mark the holes on the rack where the switch is to be installed.
3 Lift and position the switch until the rack-mount brackets are flush with the rack post, then align the
holes in the brackets with the rack holes that were marked at step 1.
4 Once the holes are aligned, insert a rack mount screw (not provided) through the bottom hole of each
bracket. Tighten both screws until they are secure.
Note. Be sure to install the screws in the bottom hole of each bracket, as shown, before proceeding.
To Next Page
Loading...
