Mounting OmniSwitch 6450 Switches Rack-Mounting 10-Port OS6450 Switches
OmniSwitch 6450 Hardware Users Guide September 2015 page 4-5
Rack-Mounting 10-Port OS6450 Switches
The following kits are available for rack mounting 10-port (1/2 width) OmniSwitch 6450 switches.
Note. Some factory-installed screws may need to be removed prior to mounting, depending on the kit
being used.
Available 10-Port Rack-Mounting Kits
Note. For information on rack mounting full width 24- and 48-port OS6450 switches, refer to
“Rack-Mounting 24 and 48-Port OS6450 Switches” on page 4-10.
General Rack-Mounting Guidelines
If you will be rack-mounting your switch(es), refer to the important guidelines below before installing.
• It is recommended that two people install the switch assembly on the rack—one person to hold the
chassis and position it on the rack, and a second person to secure the chassis to the rack using
attachment screws. (Please note that Alcatel-Lucent does not provide rack-mount screws. Use the
screws supplied by the rack vendor.)
• To prevent a rack from becoming top heavy, it is recommended that you install heavier equipment at
the bottom of the rack, whenever possible.
• Review page 4-2 for recommended chassis clearances before installing.
• If you are installing the switch on a relay rack, be sure to install and secure the rack per the rack
manufacturer’s specifications.
Kit Description
OS6450-RM-19-L Simple L-bracket for mounting one OS6450-10 or OS6450-P10 unit in a
19" rack. See page 4-6 for installation instructions.
OS6450-DUAL-MNT Two universal mounting and sliding brackets for mounting two OS6450-10
or OS6450-P10 units in a 19" rack. See page 4-6 for installation instructions.
To Next Page
Loading...
