OmniSwitch 6450 Chassis and Hardware Components Removing Expansion Modules
OmniSwitch 6450 Hardware Users Guide September 2015 page 3-39
Removing Expansion Modules
1 If applicable, remove any attached network cables from the module.
2 Loosen the thumb screws at the left and right sides of the module’s front plate.
3 When the thumb screws are loosened and the module front plate is free from the chassis, grasp the
thumbscrews and pull the module straight out of the chassis. Store the module in a static-free environment
(e.g., an anti-static bag).
To Next Page
Loading...
