Alcatel-Lucent OmniSwitch OS6450-10 - 10;100;1000 Mbps Power over Ethernet Port

To Next Page

To Previous Page

Overtemp Condition OmniSwitch 6450 Chassis and Hardware Components

page 3-48 OmniSwitch 6450 Hardware Users Guide September 2015

10/100/1000 Mbps Power over Ethernet Port – RJ-45 Pinout

Overtemp Condition

The OmniSwitch is designed to operate within a specified operating temperature as noted under the

specifications section. However, in the event that the normal operating temperature of the switch is

exceeded, the following will occur:

• Upon crossing the configured Upper Threshold, a trap will be sent. (See the OmniSwitch 6250/6450

Network Configuration Guide for information on configuring switch thresholds.)

If the temperature continues to rise and reaches the Danger Threshold, the following will occur:

• OK LED will display solid Amber.

• The switch will automatically shutdown

• Once the temperature drops to an acceptable operating level, the switch will automatically restart.

Check the following if an overtemp condition exists:

• Verify that the switch is installed properly in an environment that adheres to the installation

instructions in the following chapters.

• Verify proper airflow to the chassis.

• Time of the failure

Use the snmp station command and refer to the SNMP Configuration chapter for information on

configuring an SNMP station.

Pin Number Description

1 RX+ (-VDC)

2 RX- (-VDC)

3TX+ (+VDC)

6 TX- (+VDC)

Alcatel-Lucent OmniSwitch OS6450-10 - 10;100;1000 Mbps Power over Ethernet Port - RJ-45 Pinout; Overtemp Condition