6.1.10 ARI number
This function is only available if your installation is fitted with DECT functions
The ARI (Access Right Identifier) number identifies the system uniquely to mobiles. It contains 11 octal
digits (base 8). This number, assigned to an ETSI base by the installer, must be entered on installing
the system.
The first digit cannot be modified and is always set to 1. The cursor is automatically placed on the
second. The last digit is always either 0 or 4.
Note:
This is only relevant for IBS-DECT solution.
6.1.11 Authentication
This is used to make secure data transmission between the system and DECT mobiles by using an
authentication code during registration
Choice
: choice between "off" and "on".
If the authentication mechanism is "on", the following screen is displayed.
Each access code can have a maximum of ten digits. This can be limited to the first four digits if there
are DECT stations other than the 100/200 Mobiles.
Chapter
6
Start-Up
3EH21123USAA - Ed. 01 - April 2017 - Installation Manual 179/207
To Next Page
Loading...
Need help?
General
