To download the software, proceed as follows:
1. From OMC, connect to the system.
If it is the first connection to the system, a Warning window is automatically displayed.
2. Click on the Download button.
3. Enter the IP address and the password of the PC.
The OMC - Software download window is displayed.
4. In the Delivery file field, select the path to access the system software installed on your PC.
5. Using the ...Delivery drop-down menu in the Country & Supplier... area, select the country where
the system will be installed.
6. Click Start.
When download is complete, the message Session successfully finished is displayed.
7. Click Exit to quit the downloading tool. The system will swap on the new software version and will
be available within a few minutes.
Note:
When available, a new Uboot-loader (similar to the BIOS in previous releases) version in the OXO Connect
Compact software will not be automatically included in the list of items to be downloaded from the system. You
must select and include the new Uboot-loader version manually.
6.2.5 Services provided
OMC offers five operating modes:
1. Mode 1: Data and tool repository
2. Mode 2: Typical installation
3. Mode 3: Typical modification
4. Mode 4: Expert
5. Mode 5: Multisite
Important:
Access to modes 2, 3, 4 and 5 is password protected: pbxk1064 (using the OMC tool)
Access to modes 2 and 3 is password protected: help1954 (using the OMC Easy tool)
6.2.5.1 Mode 1: Data and tool repository
This mode is used to create .crp files offline (collective customer directories) which are used in the
Typical Installation menu.
6.2.5.2 Mode 2: Typical installation
This mode is used for online manual programming by choosing between Company and Hotel and
automatically on-line using .crp files.
Remark:
The choice Company/Hotel is only offered once. It is necessary to perform a cold reset to see it again.
6.2.5.2.1 Initial Business Installation Wizard
• IP configuration
• DHCP configuration for:
• IP devices provided by ALE International:
• Enabling/disabling DHCP server (enabled by default)
• Configuration of four DHCP IP address ranges (DHCP1 to DHCP4)
• Default values only for DHCP1 (192.168.92.10 to 192.168.92.39)
Chapter
6
Start-Up
3EH21123USAA - Ed. 01 - April 2017 - Installation Manual 191/207
To Next Page
Loading...
Need help?
General
