J2 connector
(for extension)
J1 connector
(for platform connection)
Power ON/OFF switch
2. Open the unit by removing the four screws (ST3.5x32) with a screwdriver (Phillips PH2).
3. Insert the three batteries in the open unit, into the positions B1, B2 and B3 (see the figure below).
Battery positions
B1
B2
B3
4. Connect the terminals of the batteries strictly in the order detailed below (also see the figure below).
a. Connect the black wire to the negative (black) terminal of battery B1.
b. Connect a yellow wire between the positive (red) terminal of battery B1 and the negative (black)
terminal of battery B2.
c. Connect a yellow wire between the positive (red) terminal of battery B2 and the negative (black)
terminal of battery B3.
d. Connect the red wire to the positive (red) terminal of battery B3.
Chapter
4
Installation and Cabling
3EH21123USAA - Ed. 01 - April 2017 - Installation Manual 64/207
To Next Page
Loading...
