• At least one digit (0-9)
• Special characters are not allowed
The rules to define the operator password are:
• Total length of 8 alphanumeric characters
• At least one numeric character (e.g, “HelloYou” is rejected, “11223344”, “Hello123” are accepted)
• At least two different characters (e.g. “11111111”, “aaaaaaaa” are rejected)
• No sequence of ascending or descending characters (e.g “12345678”, “abcdefgh” are rejected)
• No special character
Administration passwords and default user password must be modified at first OMC connection.
For more information about passwords, refer to the Password Management section of the document
[13].
6.2.3.2 Local Access By LAN
The default IP address for the main CPU board is 192.168.92.246 for:
• A connection to the LAN port on the main CPU board via a UTP Category 5 5-100 ohm crossover
cable.
• A connection to the switch to which the main CPU board is connected by a direct cable.
The PC IP address and network mask must be compatible with the address of OXO Connect. For
example 192.168.92.1 and 255.255.255.0.
For security reasons, the OXO Connect can be configured with an additional IP address, which is used
only for management.
To configure a management IP address:
1. Navigate to OMC: Hardware and Limits > LAN/IP Configuration
2. Select the LAN Configuration tab
3. Validate the Use Management IP Address check box
4. Enter the Management IP Address
5. Validate
6. Perform a warm reset to take the new address into account
6.2.3.3 Local V24 Access For OMC
It is possible to use OMC software to dialog with OXO Connect using a V24 connection. In this case
the network connection is not necessary.
A specific reinforced cable must link the "Config" RJ45 connector on the system CPU to the Com port
of the PC using OMC.
Wiring of the connection cable
Chapter
6
Start-Up
3EH21123USAA - Ed. 01 - April 2017 - Installation Manual 183/207