C 50
1 / 4
Alcatel Vacuum Technology France --- IPUP A100 Instruction manual
Monitoring system function table
IPUP A100P version
PUMP CONFIGURATION
Use the hand held display module to access the parameter settings.
WATER AUX
START STOP
PURGE ROOTS
SET
-- +
ENTER
CONTROL
The settings are defined in the factory and protected by an access
code which disables parameter modifications.
Press the SET key .
When the code is displayed, (0 set at factory), press the ENTER key.
The access code can be changed.
ENTER PASSWORD
CODE : * 0 *
Parameters can be transfered from one pump to another.
This can be done if the pump is to be replaced or when installing a
new pump (see C 70).
To Next Page
Loading...
