Overview: Chapter 4
QS6 Reference Manual 27
MIX EDIT MODE
Mix Edit Mode lets you change the parameters of an existing Mix. Up to 16 Programs
can be active in each Mix, and Mix Edit mode sets up how each will be played. Mix
Edit Mode allows you to:
• set the output level, effects level, and pan of each Program in the Mix;
• select which Program’s Effects Patch will be used by the Mix.
Note that you can select which Programs will be played by the different MIDI
channels and by the keyboard in multiple layers or splits without entering Mix mode.
EFFECTS EDIT MODE
Effects Edit Mode is used for setting up the Digital Signal Processing effects. Each
Effect Patch has 4 effect bus inputs, and an internal configuration of multiple effects
such as reverb, delay, and pitch-related effects (chorus, flange, etc.). You can
determine what kinds of effects are used on each bus (called a “Configuration”),
change each effect’s parameters (such as reverb decay time or chorus speed), set
modulation routings (such as having the modulation wheel change the decay time),
and set the effects mix (how much reverb, delay and chorus on the output of each
effect bus).
GLOBAL EDIT MODE
Use Global Edit Mode to set various parameters which effect the entire instrument,
such as overall master tuning, display contrast, MIDI controller settings, keyboard
sensitivity, and how the unit will respond to or generate messages in Mix Mode.
STORE MODE
Store Mode is used for storing changes of Programs, Mixes and/or Effects into the
User Bank or onto a QuadraCard PCMCIA memory card accessory. It is also used for
transmitting the QS6’s parameters over MIDI for data storage purposes, copying
sounds or effects from one Program to another, and for transferring entire Banks to or
from a Sound Card.
COMPARE MODE
Once a Program has been edited in Program Edit Mode, or a Mix has been edited in
Mix Edit Mode, the symbol “*” will appear in the display to the left of the
Mix’s/Program’s name. If [COMPARE] is pressed while in any Edit Mode, the letters
“ED:” will change to “Cm:” in the upper-left corner of the display, and you will
temporarily be hearing (and seeing) the original version of the Mix/Program. If you
are editing a Mix and press [COMPARE], the original unedited Mix is temporarily
recalled. Likewise, if you are editing a Program or its Effects Patch and press
[COMPARE], the original Program will be temporarily recalled. Pressing [COMPARE]
again switches back to the edited version, and the letters “Cm:” will revert back to
“ED:” in the display.
To Next Page
Loading...
