Chapter 6: Editing Programs
86 QS6 Reference Manual
INITIALIZING PROGRAMS
If you want to start programming from “scratch”, you can easily reset all parameters
to their default settings by re-initializing the software. Make sure your mod wheel is all
the way down before re-initializing, otherwise the "zero" position of the mod wheel will
be incorrect.
To re-initialize the QS6:
¿ Turn the power off.
¡ While holding down both Buttons [0] and [3], turn on the power.
The QS6 will come on showing Program 01 of Preset Bank 1, with the “*” flag
showing in the display and no Program Name. This is the Program Mode edit buffer,
set to the default settings. Re-initializing will also reset all Global parameters to their
default settings, and will initialize all edit buffers so that all Mix and Program
parameters are reset to their default settings. However, none of the Programs or
Mixes are changed when re-initializing the unit. You can proceed to edit, then
[STORE] at any Program location you like.
To Next Page
Loading...
