Editing Programs: Chapter 6
QS6 Reference Manual 85
COPYING SOUNDS
While editing a Program, it is helpful to be able to copy a sound to another sound in
either the same Program or a different Program, especially if you are building a split
or layered Program. This can be done very easily from within the Store function. To
copy a Sound to another sound in the same Program, or to the same sound in a
different Program:
¿ From Program Edit mode, press [STORE].
¡ Press [PAGE
▲
] twice to select Page 2 of the Store function.
¬ Use the [s VALUE] and [VALUE t] buttons to select which sound (1–4) in the
currently selected Program to copy from.
÷ Press [PAGE
▲
] to advance the cursor to the lower line of the display.
ƒ Use the [s VALUE] and [VALUE t] buttons to select which sound (1–4) in the
currently selected Program to copy to; or to select which Program (00–127) to
copy to.
ª Press [STORE] to copy the sound.
COPYING EFFECTS
While editing a Program, it is helpful to be able to copy the Effects Patch from a
different Program. This can be done very easily from within the Store function.
J
Be sure to save your changes to the edited Program before going to a new Program.
Otherwise, all your changes will be lost.
To copy the Effects Patch from a Program to another Program:
¿ Recall the Program which contains the Effects Patch you wish to copy.
¡ Press [STORE].
¬ Press [PAGE
▲
] twice to select Page 2 of the Store function.
÷ Press [s VALUE] four times to select “EFFECT”, which is the Effects Patch in the
currently selected Program to copy from.
ƒ Press [PAGE
▲
] to advance the cursor to the lower line of the display.
ª Use the [s VALUE] and [VALUE t] buttons to select which Program (0–127) to
copy to.
When selecting another Program location, the selected sound will be copied into
the same sound location in the selected Program. If you select to copy sound 2 to
Program 45, the sound will be copied into sound 2 of Program 45.
D Press [STORE] to copy the sound.
To Next Page
Loading...
