Alesis STRIKE - Page 16

16
These are the parameters on the Layers page of Voice Mode (identical for both layers):
Parameter Description
V
alues/Settings
Layer A, Layer B
Loop
This determines whether or not the sample on that layer will
loop. When set to Loop, the sample will play repeatedly when
you strike the trigger and stop playing when you strike it again
(or set its Decay to 99 if you want it to play indefinitely).
Off (---), Loop
V
el Limit
These two values determine the velocity range of the layer. If
you strike the trigger with an amount of force within that range,
it will trigger the sample.
000–127
Level
Decay
This determines how long the layer’s sound can be heard
before it decays into silence.
Off, 01–99
Pan
This is the position of the layer’s sound in the stereo field.
Left (L01–L50)
Center (MID)
Right (R01–R50)
Level
This is the volume level of the layer’s sound.
Off, 01–99
Tone
Tune
This is an offset of the tuning of the layer’s sound in half-steps
(semitones).
-12 to 0 to +12
Fine
This is an offset of the tuning of the layer’s sound in cents.
-50 to 00 +50
Filter
This is determines the cutoff frequency of the filter applied to
the layer’s sound (see Tone > Type below). The value is a
percentage of the frequency band, not the frequency itself.
00–99
Type
This is the type of filter applied to the layer’s sound.
Low-pass (LoPass)
High-Pass (HiPass)
V
elocity
V
elocity>Level
This determines how much the velocity of a strike will affect
the layer’s volume level.
00–99
V
elocity>Filter
This determines how much the velocity of a strike will affect
the layer’s filter cutoff frequency.
-99 to 00 to +99
V
elocity>Decay
This determines how much the velocity of a strike will affect
the decay time of the layer’s sound.
-99 to 00 to +99
V
elocity>Pitch
This determines how much the velocity of a strike will affect
the layer’s tuning.
-99 to 00 to +99