Alesis STRIKE - Page 17

17
These are the parameters on the FX/MIDI page of Voice Mode (they affect both layers):
Parameter Description
V
alues/Settings
F
X
EQ/Comp
This determines if equalization and compression will
be applied to the selected voice.
Off, On
Reverb Send
This is the voice’s send level for the reverb effect. It
determines how much reverb you want to apply to the
selected voice.
00–99
F
X
1 Send,
FX2 Send
These are the voice’s send levels for the F
X
1 and FX2
effects. It determines how much of each FX processor
you want to apply to the selected voice.
00–99
MIDI
MIDI Chan
This is the MIDI channel the trigger will use when
sending MIDI notes over the USB port and MIDI out.
01–16
MIDI Note
This is the MIDI note the trigger will send over its USB
port and MIDI out when struck.
000 (C-2) – 127 (G8)
Gate Time
This is the duration of the MIDI note the trigger will
send over its USB port and MIDI out when struck.
Off, 00–99 ms, 1/32, 1/16,
1/8, 1/4, 1/2. Trplt indicates a
triplet-based time division.
Note Off
This determines how the trigger will send a MIDI Note
Off message.
Not Sent: The trigger will not
send MIDI Note Off messages.
Sent: The trigger will send a
MIDI Note Off message after
the Gate Time.
A
lternate: Striking a trigger
will cause it to alternate
between sending MIDI Note
On and Note Off messages.
Other
Priority
This determines the voice’s priority in the Strike
module’s overall polyphony. If the maximum number
of polyphony voices are playing, triggering an
additional one will cause low-priority voices to stop so
that higher-priority voices can sound.
Low
Medium
High
MuteGroup
This determines the voice’s mute group. When two or
more voices are assigned to a mute group, triggering
one of the voices will immediately mute all other
voices in that mute group.
Off
01–09
Playbac
k
This determines whether the voice on this trigger will be
allowed to sound only once at any given time or multiple
times (limited only by the module’s polyphony limit).
Mono
Poly