8028 SIP Doorphone (G2) FW 3.2
Reset
To return all settings to a factory default, reboot or power cycle the 8028. Wait until the
Power Led flashes, and then press and hold the reset button until the LED start to double
flash.
Do not press the reset button until the SIP LED begins flashing.
A reset will set all configuration options to factory default including the login
password.
Once booting has completed, pressing the call button in the doorstation will cause the
device to speak its IP address over the speaker.
Document 90-00104
05/21/2020
Page 18
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
(604) 454-3792
support@algosolutions.com
To Next Page
Loading...
