8028 SIP Doorphone (G2) FW 3.2
Programming and Configuration
The 8028 is configurable using the web interface or provisioning features.
After boot up, the red call button will turn on and the 8028 will have obtained an IP
address. If there is no DHCP server the 8028 will default to the static IP address
192.168.1.111.
Before the 8028 is configured, the call button on the Door Station can be pressed to play
the IP address over the speaker. (Once the SIP Server field is populated on the 8028 web
interface, the call button will contact the pre-configured extension when pressed.) The IP
address may be discovered by downloading the Algo locator tool to find Algo devices on
your network: www.algosolutions.com/locator
Enter the IP address (e.g 192.168.1.111) into a browser such as Chrome, Firefox or
Edge. The web interface should be visible and the default password will be algo in lower
case letters.
Door or Gate Control Basics
The Door Control relay in the Control Unit can be used for unlocking a door or gate. No
power supply is required for most gate systems which require only a relay contact. Door
strikes and magnetic locks require power to lock or unlock depending on configuration.
For security, the door control relay is located in the Control Unit to eliminate entry by
tampering.
When another system is already controlling a door (handicapped access, card reader etc)
then the 8028 may be wired as an additional control system.
Door Release
Door release typically involves energizing or de-energizing a door strike which pivots to
allow a locked door to open without retraction of the latch bolt. There are two different
types of door strikes:
• “Fail Locked” (or “Fail Secure”)
• “Fail Unlocked” (or “Fail Safe”)
Fail Locked / Fail Secure Electric Strike
These require power to release and remain locked
during power failure. The door may still normally
be opened from the outside with a key, or from
inside without a key. The door control relay is used
to apply power to release the door.
Fail Unlocked / Fail Safe Electric Strike
These (as well as magnetic locks), require power
to lock and become unlocked during power failure.
Document 90-00104
05/21/2020
Page 14
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
(604) 454-3792
support@algosolutions.com
To Next Page
Loading...
