8028 SIP Doorphone (G2) FW 3.2
Advanced Settings Tab – Time
Network time is used for logging events into memory for troubleshooting.
Timezone
Select time zone.
NTP Time Servers 1/2/3/4
The interface will attempt to use Timer Server 1 and work down the list if one or more of
the time servers become unresponsive.
Supersede NTP from DHCP
By default, if an NTP Server address is provided via DHCP Option 42, it will be used
instead of the NTP servers listed below. Enable this option to ignore DHCP Option 42.
Device Date/Time
This field shows the current time and date as set on the device. If testing the device on a
lab network that may not have access to an external NTP server, the “Sync with browser”
button can be used to temporarily set the time on the device.
Note: This time value will be lost at power down, or overwritten if NTP is currently active.
Time and date are used only for logging purposes and are not typically required.
Document 90-00104
05/21/2020
Page 39
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
(604) 454-3792
support@algosolutions.com
To Next Page
Loading...
