8028 SIP Doorphone (G2) FW 3.2
• Door Sensor Normally
Open or Normally Closed
Call Button Backlight
Enable or disable the Call Button’s red backlight.
Controller Output / Door Station Output
Output can be configured to trigger one of the following Controller / Door Station events:
• In-Use
• Ring
• Call Button Press
• Door Control
• Door Sensor
• Door Alarm
• Follow Controller Input
• Follow Door Station Input
In-Use Definition
Select the meaning of the “In-Use” status to be either “Call Connected” or “Call Ringing or
Connected”.
24V Output
Set Auxiliary 24V output to be disabled, always on, or to follow door control. If set to follow
door control, then this terminal can be wired directly to the door strike (if compatible),
without needing to be also wired through the relay.
Display Auxiliary Power State on Status Page
If enabled, status of Auxiliary Power State will be shown on the status page.
Current Limit
Set current limit to low or high.
Max Door Open
Alarm will be triggered if the door remains open for longer than the selected duration.
Alarm Tone/Pre-recorded Announcement
Pre-loaded tones or custom loaded tones/recorded announcement can be used as an
alarm tone.
Interval Between Tones (seconds)
Only visible if an alarm tone has been selected in the setting above. Set interval between
the alarm tones.
Maximum Alarm Duration
Only visible if an alarm tone has been selected in the setting above. Set maximum alarm
duration.
Document 90-00104
05/21/2020
Page 30
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
(604) 454-3792
support@algosolutions.com
To Next Page
Loading...
