EasyManua.ls Logo

Algo 8028 - Page 41

Algo 8028
55 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8028 SIP Doorphone (G2) FW 3.2
Important: DHCP must be enabled if using DHCP Option 66/160/150, in order for
Provisioning to work.
One of two files can be uploaded on the Provisioning Server (for access via TFTP, FTP,
HTTP, or HTTPS):
Generic (for all Algo 8028 Doorphone) algop8028g2.conf
Specific (for a specific MAC address) algom[MAC].conf
Both protocol and path is supported for Option 66, allowing for http://myserver.com/config-
path to be used.
MD5 Checksum
In addition to the .conf file, an .md5 checksum file must also be uploaded to the
Provisioning server (for TFTP mode only). This checksum file is used to verify that the
.conf file is transferred correctly without error.
A tool such as can be found at the website address below may be used to generate this
file: http://www.fourmilab.ch/md5
The application doesn’t need an installation. To use the tool, simply unzip and run the
application (md5) from a command prompt. The proper .md5 file will be generated in the
same directory.
If using the above tool, be sure to use the “-l” parameter to generate lower case letters.
Generating a generic configuration file
1. Connect the 8028 to the network
2. Access the 8028 Web Interface Control Panel
3. Configure the 8028 with desired options
4. Click on the System tab and then Maintenance.
5. Click “Download” to download the current configuration file
6. Save the file settings.txt
7. Rename file settings.txt to algop8028g2.conf
8. File algop8028g2.conf can now be uploaded onto the Provisioning server
If using a generic configuration file, extensions and credentials have to be entered
manually once the 8028 SIP Doorphone has automatically downloaded the configuration
file.
Generating a specific configuration file
1. Follow steps 1 to 6 as listed in the section “Generating a generic configuration
file”.
2. Rename file settings.txt to algom[MAC address].conf (e.g.
algom0022EE020009.conf)
3. File algom[MAC address].conf can now be uploaded on the Provisioning server.
Document 90-00104
05/21/2020
Page 41
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
(604) 454-3792
support@algosolutions.com

Other manuals for Algo 8028

Related product manuals