8028 SIP Doorphone (G2) FW 3.2
Cancel Door Open Relay once Door Opened
The door opening control can be set for activation (using the ‘Open Code’) up to 30
seconds (set by the ‘Relay Time’ setting) to allow sufficient time for entry. For security, the
8028 can be configured to cancel Door Opening once the door is opened to prevent
“tailgating” by unauthorized personnel.
Unlock Door Indefinitely until Cancelled
The door opening control can be set to unlock indefinitely (using the ‘Latch Open Code’)
until cancelled (using the ‘Release Code’) that locks it again. This allows an entrance to
be used repeatedly for a period of time without requiring multiple activations of the door
control relay.
Anti-Door Tamper
A feature of the 8028 is to ring the telephone(s) with a warning alert in the event a door is
ajar due to tampering (such as a door blocked open after being legitimately released for a
visitor). Requires physical door sensor (not included).
In-Use and Ring
Either the Controller or Door Station can be configured to provide a dry contact output
during ring or in-use for channel selection (typically) of third party video monitoring
systems.
Document 90-00104
05/21/2020
Page 9
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
(604) 454-3792
support@algosolutions.com
To Next Page
Loading...
