Alienware 13 - Removing the Display Assembly; Prerequisites; Procedure

Removing the display assembly
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the
instructions in
After Working Inside Your Computer. For more safety best practices, see the Regulatory Compliance
home page at dell.com/regulatory_compliance.
Prerequisites
1 Remove the base panel.
2 Follow the procedure from step 1 to step 5 in “Removing the solid-state drive”.
3 Follow the procedure from step 1 to step 8 in “Removing the palm rest”.
Procedure
1 Open the display as far as possible.
2 Remove the screws that secure the hinge caps to the display hinges.
3 Slide and lift the hinge caps o the display hinges.
1 screws (2) 2 hinge caps (2)
4 Close the display and turn the computer over.
5 Peel o the adhesive tape from the wireless card.
6 Remove the screw that secures the wireless-card bracket to the wireless card.
39