FX Model – Phaser
The Phaser combines the original signal and a copy of the signal with phase
shifting applied at different frequencies. This causes some frequencies to cancel
out at the same time as others are reinforced.
Rate – Adjust the speed of the frequency sweep.
Tone – Adjust to select the centre frequency the phaser will work around.
Width – Select to offset left and right outputs and create a wider sound.
Width has no effect if Phaser is inserted into a mono channel.
Resonance – Adjust how prominent the reinforced frequency is.
Phaser Mode – Set the how wide a range of frequencies the phaser moves
through.
To Next Page
Loading...
