Rockwell Automation Publication 1791ES-UM001G-EN-P - November 2016 169
Specifications Appendix D
North America
In North America, the TÜV-Rheinland type approval includes Guard I/O
compliance to the relevant standards and related information including the
following:
• U.S. standards - ANSI RIA15.06, ANSI B11.19, NFPA 79
• The modules are UL-certified functionally safe and carry the NRGF
label, when product is marked (only 1791ES modules).
Japan
In Japan, type test requirements are provided in Article 44 of the Industrial
Safety and Health Law. These requirements apply to complete systems and
cannot be applied to a module by itself. Accordingly, to use the module in
Japan as a safety device for press machine or shearing tool pursuant to Article
42 of the above-mentioned law, it is necessary to apply for testing of the entire
system (only 1791ES modules).
EC Directives
These products conform to the EMC Directive and Low-voltage Directive. For
additional information, see the relevant installation instructions.
EMC Directive
Rockwell Automation devices that comply with EC directives also conform to
the related EMC standards so that they can more easily be built into other
devices or the overall machine. The actual products have been checked for
conformity to EMC standards. Whether they conform to the standards in the
system used by the customer, however, must be confirmed by the customer.
EMC-related performance of Rockwell Automation devices that comply with
EC directives vary depending on the configuration, wiring, and other
conditions of the equipment or control panel in which the Rockwell
Automation devices are installed. The customer must, therefore, perform the
final check to confirm that devices and the overall machine conform to EMC
standards.
Compliance with EC Directives
EtherNet/IP products that comply with EC directives must be installed as
follows:
• All Type IP20 EtherNet/IP units must be installed within control
panels.
To Next Page
Loading...
