Allen-Bradley 1791ES-IB8XOBV4 - Configure the I;O Modules; Set the IP Address

Rockwell Automation Publication 1791ES-UM001G-EN-P - November 2016 75
Chapter 5
Configure the I/O Modules
Use the Studio 5000 Logix Designer® application to configure the modules.
At the bottom of a dialog box, choose Help for information about how to
complete entries in the dialog box. At the bottom of a warning dialog box,
choose Help to get information about that specific error.
Set the IP Address
If the network uses 192.168.1.x, use the rotary switches on the module to set
the last octet of network IP address. Valid numbers range from 001…254.
Figure 31 - Example Network Address
Topic Page
Add Modules to the I/O Configuration Tree 77
Configure the Module Properties 79
Configure the Safety Connections 86
Configure the Module Inputs 88
Configure the Test Outputs 90
Configure the Module Outputs 91
Save and Download the Module Configuration 92
WARNING: When you change switch settings while power is on, an
electrical arc can occur. This could cause an explosion in hazardous location
installations. Be sure that power is removed or the area is nonhazardous
before proceeding.
4
2
6
8
0
X100 X1X10
4
2
6
8
0
4
2
6
8
0
This example shows the switches set at 163
with a network address being 192.168.1.163.
1791ES Network Address Switches
1732ES Network Address Switches
4
2
6
8
0
X100 X1X10
4
2
6
8
0
4
2
6
8
0