Allen-Bradley 1791ES-IB8XOBV4 - Make Connections for 1732 ES Modules; Power Connections; Power Pass through

Rockwell Automation Publication 1791ES-UM001G-EN-P - November 2016 55
Install the Module Chapter 3
Make Connections for 1732ES
Modules
See the Ethernet Design Considerations Reference Manual, publication
ENET-RM002
, for information about Ethernet cable.
Power Connections
This section describes the power connectors and recommended cables.
Table 12 - Power Connector Pin
Description
Table 13 - Recommended Power Cables
See http://www.ab.com/en/epub/catalogs/6005557/6005561/10508712/
10513424/10513435/Introduction.html for more information.
Power Pass Through
The power that the module requires is supplied via a 4-pin mini-style
connector system. The module receives its required power through the male
connector on the left. A female connector on the right is also provided so that
power can be daisy chained from module to module.
Pin No. Signal
1 Output +24V DC power
(1)
(1) Not required for 1732ES-IB16 modules.
2 Input +24V DC power
3 Input power, common
4 Output power, common
(1)
Description Cat. No.
Mini right angle female to flying leads cord set 889N-R4AFC-6F
(1)
(1) Replace -6F (1.8 m [6 ft]) with -12 (3.7 m [12 ft]) or -20 (6.1 m [20 ft]) for additional standard cable lengths.
Mini straight female to flying leads cord set 889N-F4AFC-6F
(1)
Mini right angle male to flying leads cord set 889N-E4AFC-6F
(1)
Mini straight male to flying leads cord set 889N-M4AFC-6F
(1)
Mini right angle male to right angle female patch cord 889N-R4AFNE-2
(2)
(2) Replace -2 (2 m [6.6 ft]) with -5 (5 m [16.4 ft]) or -10 (10 m [32.8 ft]) for additional standard cable lengths.
Mini straight male to straight female patch cord 889N-F4AFNM-2
(2)
IMPORTANT Use power pass through (daisy chaining of power) only for ‘de-energize to
trip’ (safety state = OFF) applications.
Male Input
(mates to female cable end)
Female Output
(mates to male cable end)