Rockwell Automation Publication 1791ES-UM001G-EN-P - November 2016 49
Install the Module Chapter 3
Mount the 1732ES Modules on a Wall or Panel
To mount the module on a wall or panel, use the screw holes provided in the
module.
Follow these steps to mount the module.
1. To lay out the drill locations, use the mounting holes in the module as a
guide.
2. Mark the center of drill location with a pencil or marker.
3. Use a center punch to mark the drill locations.
4. Use a 4.5 mm (0.177 in.) drill to make the pilot holes.
5. Mount the module with two #8 (M4) screws.
ATTENTION: To meet safety and EMC requirement this module must be
mounted on a flat conductive and fireproof surface.
To Next Page
Loading...
