Rockwell Automation Publication 1791ES-UM001G-EN-P - November 2016 59
Install the Module Chapter 3
EtherNet/IP Connections
This section describes the EtherNet/IP connector and sample cables.
Table 16 - EtherNet/IP Connector Pin Description
Table 17 - Sample EtherNet/IP Cables
See http://www.ab.com/en/epub/catalogs/6005557/6005561/10514505/
10515166/Introduction.html for additional information.
ATTENTION: To comply with the CE Low Voltage Directive (LVD), this
equipment and all connected I/O must be powered from a source compliant
with Safety Extra Low Voltage (SELV) or Protected Extra Low Voltage (PELV).
Pin No. Signal
1Tx+
2Rx+
3Tx-
4Rx-
5 Shell/Shield
Description Cat. No.
M12 D-Coded straight to RJ45 patchcord 1585D-M4UBJM-2
(1)
(1) Replace -2 (2 m [6.6 ft]) with -1 (1 m [3.3 ft]), -5 (5 m [16.4 ft]) or -10 (10 m [32.8 ft]) for additional standard cable lengths.
M12 D-Coded straight to flying leads cordset 1585D-M4UB-2
(1)
M12 D-Coded straight to M12 straight patchcord 1585D-M4UBDM-2
(1)
M12 D-Coded right angle to M12 right angle patchcord 1585D-E4UBDE-2
(1)
To Next Page
Loading...
