Publication 2100-IN012B-EN-P - April 2005
5-2 Installing and Removing Plug-In Units
Figure 5-2 Opening the Door of a Unit with a Vertical Operating Handle
.
1. Remove door-mounted devices and/or wiring, if necessary.
2. Remove hinge pins by sliding upward with a flathead screwdriver.
NOTE: The control station can be hung on front of the unit using square
holes adjacent to top unit latch
TIP
It is not necessary to remove the unit door to remove a
unit from a section. However, steps 1 and 2 below may
still be necessary even when door is not removed.
To Next Page
Loading...
