Publication 1747-UM655B-EN-P - June 2007
68 Communicating with the DeviceNet Network from Another Network
6. Click Accept and then OK.
The new driver is added to the list of Configured Drivers in
RSLinx software. (Your list contains the drivers you have
configured.)
Configure the DeviceNet Network Pass-through Driver
Before you can communicate with the 1747-SDN module via the
Ethernet network, you must configure the DeviceNet pass-through
driver (catalog number 1747-SDNPT) by using RSLinx software,
version 2.10 or later. You must also have configured the Ethernet to
PLC-5/SLC-5/5820-EI driver as described in the previous section and
configured the SLC 5/05 processor’s Ethernet communication channel
as described in Appendix B.
Follow these steps to configure the DeviceNet network Pass-through
driver.
1. Start RSLinx software.
To Next Page
Loading...
