Publication 1747-UM655B-EN-P - June 2007
58 Configuring the DeviceNet Network
The Edit I/O Parameters dialog appears for the RediSTATION
operator interface.
2. Verify that the Polled box is checked and that the Rx Size and Tx
Size are each 1 byte.
3. Click OK to close the Edit I/O Parameters dialog for the
RediSTATION operator interface.
4. Click OK again.
You are prompted to download the changes to the 1747-SDN
module.
5. Click Yes to download the new configuration.
AutoMap the Devices into the Scanlist
Follow these steps to automatically map the photoeye and
RediSTATION operator interface to the SLC 500 processor.
TIP
If you want to know how to map the devices manually, click
Help at the bottom of the dialog and select Map device input
data manually.
To Next Page
Loading...
