Allen-Bradley E300 - Page 39

Rockwell Automation Publication 193-QR004B-EN-P - January 2017 39
Appendix A
44 LIOClWyeDelta2W Local I/O Wye/Delta
2 Wire Control with
Closed Transition
A selector switch is the control source for a wye/delta starter with a closed transitions
45 LIOOpWyeDelta3W Local I/O Wye/Delta
3 Wire Control with
Open Tr
ansition
Two momentary push buttons are the control sources for a wye/delta starter with an open
transitions
46 LIO2Speed2Wire Local I/O 2-Speed 2 Wire Control A maintained selector switch is the control source for a 2-speed starter
47 LIO2SpeedFB2Wire Local I/O 2-Speed
2 Wire Control with
F
e
edback Protection
A maintained selector switch is the control source for a 2-speed starter, and the E300 relay will
trip if the contactor auxiliary is not closed of the contactor
48 LIO2Speed3Wire Local I/O 2-Speed 3 Wire Control Three momentary push buttons are the control sources for a 2-speed starter
49 CustomOverload Custom Overload
A custom DeviceLogix program can be used to control the E300 relay with an Overload
operati
ng mode
50 CustomNonRev Custom Non-reversing
A custom DeviceLogix program can be used to control the E300 relay for a non-reversing
start
er
51 CustomReverser Custom Reversing A custom DeviceLogix program can be used to control the E300 relay for a reversing starter
52 CustomWyeDelta Custom Wye/Delta A custom DeviceLogix program can be used to control the E300 relay for a wye/delta starter
53 Custom2Speed Custom 2-Speed Starter A custom DeviceLogix program can be used to control the E300 relay for a 2-speed starter
54 CustomMonitor Custom Monitor The E300 relay can be used as a monitoring devic
e
, and all protections can be disabled
Table 1 - E300 Relay Preset Configurations (Parameter 164)
Value Enumeration
Operating Mode
Description
Control
Source
Starter Type Control Option