Access Procedures 3-13
6. Remove the four screws which secure the Fiber Optic Adapter board to
the stand-offs on the back of the Control Frame.
7. Remove the Fiber Optic Adapter Board from the Control Frame.
Installation
Install the 700H Fiber Optic Adapter Board in reverse order of removal,
while referring to Torque Specifications on page 3-1
.
Removing the Covers from
the Power Structure
Moving the Control Frame
Removal
1. Remove power from the drive. Refer to Removing Power from the
Drive on page 3-3.
PZ2
0.9 N-m
(8 lb.-in.)
To Next Page
Loading...
