Rockwell Automation Publication 1783-UM010C-EN-P - June 2019 119
Troubleshoot Chapter 10
Hardware Setup
The following list is the hardware preparation that was designed for
this example.
1. Set NIC on the computer to DHCP.
2. Connect the management interface cable on the Stratix® 5950 Security
Appliance to NIC on computer.
3. Connect serial cable from console port on Stratix 5950 appliance to
serial port on the computer.
4. Plug in the Stratix 5950 appliance and apply power.
5. Hold in Express Setup button for 5 seconds.
This action reloads the ASA configuration and reboots the device.
6. Wait 5 minutes for the device to restart.
Uninstall an Old SFR Module
Follow these steps to uninstall an old SFR module.
1. Use PuTTY to connect to the serial port of the device.
2. stratix5950> enable
3. Press Enter when prompted for “Password:”
To Next Page
Loading...