38 Rockwell Automation Publication 1783-UM010C-EN-P - June 2019
Chapter 3 Configure the Security Appliance
Prerequisites
Follow these prerequisite steps before you attempt to configure the
Stratix® 5950 Security Appliance. There are two deployment configurations
that are described in this chapter. You must select a deployment configuration
mode: Inline or SPAN Port.
All steps that are listed in this chapter apply to both configurations unless
otherwise noted.
Here is what you need:
• Deployment Configuration Guide
•Power supply
•Console cable
•Ethernet cable
•Device
• Personal computer
Ethernet Devices
Identify the Ethernet devices that you are going to connect to the device:
switch, servers, and workstations or personal computers. Verify that each
device has a network interface card (NIC) for connecting to Ethernet ports.
Partially configuration of the device using Cisco ASA commands through the
console port is required. An ASCII terminal or a personal computer that is
running terminal emulation software to connect to the console port is needed.
1. Make sure that you are using a personal computer that is configured with
a supported operating system. For a list of supported operating systems,
see the release notes at:
http://www.cisco.com/c/en/us/td/docs/security/asdm/7_6/release/
notes/rn76.html
2. Install the latest version of Java.
Go to https://www.java.com
3. Install a Terminal Emulator, such as PuTTY.
4. Obtain the Stratix 5950 security appliance from the factory, no cables
connected.
5. Obtain the cable, DB9-to-RJ45 that is shipped with the appliance.
6. Determine the Management network for the device, for example:
10.0.1.0.24
7. Contact your Network Administrator, and obtain two IP addresses in
the Management network.
a. IP address 1 is for the ASA management IP address, for example:
10.0.1.1
b. IP address 2 is for the SFR management IP address, for example:
10.0.1.2
To Next Page
Loading...