Rockwell Automation Publication 1783-UM010C-EN-P - June 2019 39
Configure the Security Appliance Chapter 3
8. Determine the network that you want to use the appliance to monitor,
for example: 192.168.1.0/24 (Inline configuration mode only)
9. Contact your Network Administrator and obtain an IP address in the
network that you want to monitor, for example: 192.168.1.218 (Inline
configuration mode only)
10. Obtain a list of DNS servers from your Network Administrator.
Device Setup
Follow these steps to configure the Cisco ASA software.
1. Set NIC on your computer to DHCP.
Next, you must connect the Management interface on the Stratix 5950 security
appliance to the NIC on your computer.
2. Connect the serial cable from Console port on the security appliance to
the serial port on your computer.
3. Apply power to the security appliance.
4. Wait until the EIP Mod status indicator turns solid green.
The green status indicator flashes until complete, about 5 minutes.
5. Connect to https://169.254.0.1/admin.
Ignore self-signed certificate warnings.
6. Click either Install ASDM Launcher or Run ASDM, depends on what
your system displays.
If you are required to click Install ASDM Launcher, steps 8…10 apply.
7. When prompted for a username and password, leave the fields blank and
click login.
8. Run the dm-launcher.msi file that was downloaded.
9. Install using the default options.
Cisco ASDM-IDM Launcher launches automatically.
To Next Page
Loading...