Rockwell Automation Publication 1783-UM010C-EN-P - June 2019 51
Configure the Security Appliance Chapter 3
Configure the HTTPS Certificate Information
Follow these steps to configure the HTTPS certificate.
1. Disconnect the temporary connected network cable from your
computer.
2. Change your NIC from DHCP to your normal network configuration.
3. Connect the network cable a switch in the Management network.
4. Run Cisco ASDM-IDM Launcher.
5. Connect using the ASA management IP address, and the new password
that was set during the Startup Wizard.
6. Ignore the certificate warnings.
ASDM launches.
7. Run Wizards -> ASDM Identity Certificate Wizard.
8. Select Simple Mode.
9. Then select Export Generated Identity Certificate.
10. Save the file as asa.cer.
11. Run Wizards -> ASDM Identity Certificate Wizard.
12. Select ASA FirePOWER Module.
13. Then select Export Generated Identity Certificate.
14. Save the file as sfr.cer.
After this procedure, do the following:
1. Go to ASDM -> Save ASA Changes.
2. Go to ASDM -> Tools -> System Reload… -> Schedule Reload.
3. Close ASDM.
4. Open Java Control Panel -> Security -> Manage Certificates.
5. Select Certificate type as Secure Site.
6. Import asa.cer.
7. Import sfr.cer.
To Next Page
Loading...