Rockwell Automation Publication 1783-UM010C-EN-P - June 2019 121
Troubleshoot Chapter 10
6. Wait until the "Console session:" shows "Ready"
7. stratix5950# session sfr console
8. Log in with: username=admin, password=Admin123
9. asasfr-boot>setup
10. Complete the steps with the networking information for the SFR IP
address.
11. system install noconfirm ftp://
FTP_IP_ADDRESS/asasfr-sys-5.4.1-213.pkg
Enter the username/password, and the system begins to download the
package. It shows ‘Download…’
After the package is downloaded, it takes about 60 minutes to complete
the following steps.
a. Extracting
b. Upgrading
c. Starting upgrade process
d. Populating new system image
e. The system is going down for reboot NOW!
After the system reboots, wait another 60 minutes until ‘show
module sfr’ shows that the status is ‘Up’.
12. stratix5950(config)# session sfr console
13. Log in with: username=admin, password=Sourcefire
14. Accept the EULA, when prompted.
15. Change the admin password, when prompted.
16. Change the networking settings to the SFR IP address.
17. Wait until this step completes: ‘Applying 'Default Allow All Traffic'
access control policy.’
It takes a few minutes.
To Next Page
Loading...