Alliance Laundry Systems SWT520*M - Page 95

39201 93
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Troubleshooting (NetMaster Models)
EC:2E Firmware Update Failed, S/
W Not Intact
Bad firmware in reader. Card Reader may need to be replaced.
EC:2F Firmware Updated, S/W
Not Intact
Bad firmware in reader. Card Reader may need to be replaced.
EC:30 Timeout Error Card Reader may need to be replaced.
EC:31 Hotlisted Card Inserted
Into Reader
Card hotlisted. Control will destroy card.
EC:50 Loyalty Purse Read Error Try card again. If error persists, card may be bad.
EC:56 Loyalty Purse Write Error Try card again. If error persists, card may be bad.
Right most
DP
(decimal
point)
Lit
Network Communication
Error
Communication problem. Wait for 1.5 minutes for error to clear. If
it doesn’t, power-down and power-up the machine. If error persists,
control or Network Board may need to be replaced.
Err Coin Error Invalid coin pulse.
Alrm Break-in Alarm Error Service door or coin vault switches.
OFF Break-in Alarm Shutdown
Error
Service door or coin vault switches.
E:FL Fill Error Pressure switch fails to open in 30 minutes in any fill agitate cycle.
E:dr Drain Error Maximum drain time exceeded or water sensed at end of spin step.
E:00 General Error Re-aim Micro-wand and try again.
E:01 Proximity Error Micro-wand is improperly aimed at infrared communicator (angle
or distance). Re-aim Micro-wand and try again.
E:02 IR Communication
Disconnection
Micro-wand removed before communication complete. Re-aim
micro-wand and try again.
E:05 Invalid Value
Communication
Invalid code downloaded from Micro-wand to Electronic Control.
Before downloading, ensure data is for current machine type.
E:07 Inoperative Control Replace control.
E:08 Inoperative Control Replace control.
E:09 Proximity Error Micro-wand is improperly aimed at infrared communicator (angle
or distance). Re-aim Micro-wand and try again.
EI:0A Proximity Error Micro-wand is improperly aimed at infrared communicator (angle
or distance). Re-aim Micro-wand and try again.
Display Description Cause/Corrective Action