EasyManuals Logo

Allied Telesis AT-8000S Series Installation Guide

Allied Telesis AT-8000S Series
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
Page 16
Allied Telesis AT-8000SSwitch
Switch Installation Guide
Mode LEDs
Selecting a particular mode determines what information is displayed on the port LED. For example, if the mode
selected is "COL", then the LED on each port indicates the collision status of that port.
The following figure illustrates the mode LEDs.
Figure 11: Mode LEDs
The mode LED indications are described in the following table:
24/48 Port Device Stacking LEDs
The following figure illustrates the stacking LEDs.
Figure 12: Stacking LEDs
Table 1: Mode LED Indications
LED Description LED Indication Description
COL Green Data collisions are occurring on the port.
Off No data collisions are occurring on the port.
SPD Green Link is established at 100Mbps.
Off Link is established in 10Mbps.
FDX Green A Full Duplex mode connection is established.
Off A Half Duplex mode connection is established.
ACT
Green
Port is transmitting and/or receiving data. This the default
mode.
Off No activity is established.

Table of Contents

Other manuals for Allied Telesis AT-8000S Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AT-8000S Series and is the answer not in the manual?

Allied Telesis AT-8000S Series Specifications

General IconGeneral
Operating Temperature0°C to 40°C (32°F to 104°F)
Storage Humidity5% to 95% non-condensing
Switching Capacity104 Gbps
Forwarding Rate77.4 Mpps
VLANs4, 094
Layer 3 FeaturesStatic routing, RIP v1/v2
ManagementWeb-based
Operating Humidity10% to 90% non-condensing

Related product manuals