Allied Telesis AT-8000S Series Installation Guide

Page 22
Allied Telesis AT-8000S Switch
Switch Installation Guide
Chapter 2. Installation
This section contains information for installing the device, and includes the following sections:
• Preparing for Installation
• Installing the Device
• Connecting the Device
• Rack Installation
Preparing for Installation
This section provides an explanation for preparing the installation site, and includes the following topics:
• Preparing for Installation
• Site Requirements
• Unpacking
Safety Precautions
Please review the following safety precautions before you begin to install the AT-8000S.
Note
The  indicates that a translation of the safety statement is available in a PDF document titled
“Translated Safety Statements” on the Allied Telesis website at www.alliedtelesis.com and on the
documentation CD shipped with this product.
Warning
Class 1 Laser product.  L1
Warning
Do not stare into the laser beam.  L2
Warning
To prevent electric shock, do not remove the cover. No user-serviceable parts inside. This unit contains
hazardous voltages and should only be opened by a trained and qualified technician. To avoid the
possibility of electric shock, disconnect electric power to the product before connecting or disconnecting
the LAN cables.
 E1

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing