Hardware Reference 49
C613-03092-00 REV J
Overrides The switch pauses briefly during startup messages to display the following
prompt:
Boot fallback software (Y)?
If you do nothing, the installed base package is loaded along with a
preconfigured startup script. For troubleshooting, change the process by using
the following keys.
Regular output AlliedWare operating system bootloader and product software display a series
of messages similar to those in the following figure during routine startup.
4 Hardware boards and software components are initialised. Base or Fallback
5 The startup configuration script that the user specified is
executed.
Base or Fallback
6 Startup is complete and the switch starts switching traffic if
devices connected to it are sending traffic.
Base
Stage This happens... Done by...
Pressing this key... Forces the switch to...
Y Load the fallback software instead of the base package.
S (skip) Load the base package and skip the startup configuration script.
Ctrl+B Display a bootloader prompt. To upgrade a bootloader file, load the
new
.bin file into the file system, and enter the command:
copy filename.bin bootloader
For information about the load command, see the Managing
Configuration Files and Software Versions chapter in the Software
Reference.
Ctrl+D Enter diagnostics mode. For more information, see “Diagnostics” on
page 58.
------------------------------------------------------------
Bootloader v3-00, built 6 Mar 2006
------------------------------------------------------------
Identifying RAM .................................. 512 MB
Initial RAM test ................................. passed
Relocating the bootloader to execute from RAM .... done
Boot fallback software (Y) ?
Initialising file system access .................. done
Booting preferred base package: AT9924s_311-00.pkg
Installing system.img (1775093 bytes) ............ done
Initiating system software ....................... done
------------------------------------------------------------
AlliedWare v3.1.1-00, built 23 Jun 2006
------------------------------------------------------------
Initialising file system access .................. done
Validating package licence ....................... done
Installing product_apps.img (9705444 bytes) ...... done
Executing configuration script <startup.cfg>
Switch startup complete
To Next Page
Loading...
