Installation
44
Using the
Provider Unit on
a Desktop
To use the Provider unit on a desktop, perform the following procedure:
1. Position the Provider unit upside down and attach the rubber feet
provided to the bottom of the unit as shown in Figure 10.
Figure 15. Provider Unit - Installing Feet
2. Place the Provider unit right side up on a flat, secure surface
leaving 1 to 2 inches of space around the unit for ventilation.
3. Go to “Setting the Provider Unit DIP Switches” on page 45.
Wall-Mounting
the Provider Unit
Refer to Appendix B, ”AT-MMCWLMT Kit Installation” on page 55 for
instructions to wall mount the AT-MMC6000 Series Media Converter.
Rack Mounting
the Provider Unit
To wall mount the AT-MMC6000 Series Media Converter, it must be
installed into an AT-MMCR18 chassis, which is then installed in an
equipment rack.
The AT-MMCR18 chassis is provided separately from the
AT-MMC6000 Series Media Converter.
Perform the following procedure to rack mount the AT-MMC6000 Series
Media Converter:
1. Before installing the media converter in the AT-MMCR18 chassis, go
to “Setting the Provider Unit DIP Switches” on page 45 and then return
to Step 2.
To Next Page
Loading...
