AT-MMC6000 Series Installation Guide
47
Cabling the
Provider Unit
To cable the Provider unit, perform the following steps:
1. Connect an Ethernet cable from the Provider Ethernet port to the
Service Provider box in your wiring closet, as shown in Figure 17.
Figure 17. Provider Unit Ethernet Port to Internet Service Provider
2. Connect the VDSL Line port on the Provider unit to the
VDSL wall jack or the building VDSL line in the building with either a
phone line for the AT-MMC6005 or a coax cable for the AT-MMC6006
as shown in Figure 18. This connection allows the Provider unit to
communicate directly with the Subscriber unit.
Figure 18. Provider Unit to Wall Plug or Interior VDSL Line in Building
3. Go to “Powering On the Provider Unit” on page 48.
To Next Page
Loading...
