Allied Telesis AT-x230-28GP - Snmp-Server Location

C613-50104-01 REV A Command Reference for x230 Series 1636
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SNMP COMMANDS
SNMP
-SERVER LOCATION
snmp-server location
Overview This command sets the location of the system. The location is:
• displayed in the output of the show system command
• stored in the MIB object sysLocation
The no variant of this command removes the configured location from the system.
Syntax
snmp-server location <location-name>
no snmp-server location
Mode Global Configuration
Example To set the location to “server room 523”, use the following commands:
awplus# configure terminal
awplus(config)# snmp-server location server room 523
Related
Commands
show snmp-server
show system
snmp-server contact
Parameter Description
<location-name> The location of the system, from 0 to 255 characters long. Valid
characters are any printable character and spaces.