47
C613-50104-01 REV A Command Reference for x230 Series 1644
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LLDP Commands
Introduction
Overview LLDP and LLDP-MED can be configured using the commands in this chapter, or by
using SNMP with the LLDP-MIB and LLDP-EXT-DOT1-MIB (see the Support for
Allied Telesis Enterprise MIBs in AlliedWare Plus).
The Voice VLAN feature can be configured using commands in VLAN Commands
chapter.
For more information about LLDP, see the LLDP Feature Overview and
Configuration Guide.
LLDP can transmit a lot of data about the network. Typically, the network
information gathered using LLDP is transferred to a Network Management System
by SNMP. For security reasons, we recommend using SNMPv3 for this purpose (see
the SNMP Feature Overview and Configuration Guide).
LLDP operates over physical ports only. For example, it can be configured on switch
ports that belong to static or dynamic channel groups, but not on the channel
groups themselves.
Command List •“clear lldp statistics” on page 1646
•“clear lldp table” on page 1647
•“debug lldp” on page 1648
•“lldp faststart-count” on page 1650
•“lldp holdtime-multiplier” on page 1651
•“lldp management-address” on page 1652
•“lldp med-notifications” on page 1653
•“lldp med-tlv-select” on page 1654
•“lldp non-strict-med-tlv-order-check” on page 1657
•“lldp notification-interval” on page 1658
•“lldp notifications” on page 1659
To Next Page
Loading...
