AlphaTheta DJM-V10 - Chassis Section (Top part)

82
DJM-V10
1
2 3 4
A
B
C
D
E
F
1
2 3 4
[2] Chassis Section (Top part)
[2-1] Jumper wire
1 Disconnect the one FFC and 3 connectors.
(CN2, 10, 11, 14)
2 Release the 3 points of FFC and jumper
wires.
[2-3] USBA and USBB Assy
1 Release the 5 points of jumper wire.
[2-2] USBP Assy
1 Disconnect the 2 connectors.
(CN3151, 3152)
2 Remove the 2 screws.
(BBZ30P060FTC)
3 Remove the USBP Assy while sliding it in the
direction of the arrow.
1
2
2
2
×4×4
CN3152CN3152
CN3151
CN3151
CN2
CN2
CN2
CN2
CN10
CN10
CN10
CN10
CN4001
CN4001
CN4001
CN4001
CN4002
CN4002
CN4002
CN4002
CN14
CN14
CN11
CN11
2
1
1
1
1
1
1
1
2
3
USBP Assy
g Jumper wires styling
Reinforcement plate
of FFC is long
Reinforcement plate
of FFC is short
CN4002 connects after turning it half a turn
counterclockwise while looking at the product
from the front.
Install so that the jumper wire between
USBP Assy and USBA Assy, the jumper wire
between MAIN Assy and AIN Assy do not touch.