AlphaTheta DJM-V10 - Page 83

83
DJM-V10
5
6 7 8
5
6 7 8
A
B
C
D
E
F
[2-4] MTRM Assy
1 Remove the 2 screws
(BBZ30P060FTC)
2 Disconnect the BtoB connector and then
remove the MTRM Assy with stay.
(CN6251)
2 Remove the 2 screws and then remove the
USBB Assy with stay.
(BBZ30P060FTC)
3 Disconnect the one connector.
(CN3101)
4 Remove the 2 screws and then remove the
USBA Assy with stay.
(BBZ30P060FTC)
5 Disconnect the one connector.
(CN3051)
4
2 2
4
5
3
USBA Assy
USBA Assy
USBB Assy
CN3051CN3051
1 1
2
MTRM Assy
MTRM Assy
CN3101CN3101
CN5201
CN5201
CN6251
CN6251
NG exampleNG example
The hook is not inserted into
the slit of the board.
The hook is not inserted into
the slit of the board.
g Notes on assembling
Attach so that the hook is inserted
into the slit of the board.
The screw is attached when the positioning
rib (_ part) is at the position shown in
the figure below.
1
21
2
Screw tightening order
Screw tightening order
2 1