26
WEP, and WPA are not supported. The WPA2-Enterprise protocol is not supported, which requires
individual user name and password.
The supported router’s Security Mode should be one of the following (different vendors could use
different names):
• Auto
• Mixed
• WPA-PSK/WPA2-PSK
• WPA/WPA2 Personal.
The Authentication Mode of the router should be one of the following:
• Auto
• Mixed
• WPA2-PSK.
The Encryption Mode should be one of the following:
• Auto
• AES
• TKIP/AES
• CCMP.
TKIP encryption is not recommended, since it is slower.
The information above is also listed by taping the information icon in the Connect to WiFi page of the
App, as shown in the figure below.
In most cases, the default configurations of most new routers are supported by Sentinare. However,
some routers have the WPS (Wi-Fi Protected Setup) feature enabled by default (such as some Hitron
routers provided by Shaw Communications in Canada), which is not supported by Sentinare. Please turn
off the WPS setting by logging into the admin page of your router, usually with IP address 192.168.0.1,
and then adjust the WiFi settings according to the requirements above.
The following is an example of the WiFi setup page of a router:
To Next Page
Loading...