5.9.2 Disconnecting hydraulic hoses .............................................................................................. 48
5.10 Three-point hitch frame ......................................................................................................... 49
6 Commissioning ......................................................................................... 50
6.1 Checking the suitability of the tractor .................................................................................... 51
6.1.1 Calculating the actual values for the total tractor weight, tractor axle loads and load
capacities, as well as the minimum ballast ........................................................................... 51
6.2 Securing the tractor/machine against unintentional start-up and rolling ............................... 55
7 Coupling and uncoupling the machine ................................................... 56
7.1 Coupling the machine............................................................................................................ 57
7.2 Uncoupling the machine ........................................................................................................ 59
8 Adjustments............................................................................................... 60
8.1 Working depth of the tines .................................................................................................... 60
8.1.1 Mechanical depth adjustment ............................................................................................... 60
8.1.2 Hydraulic depth adjustment ................................................................................................... 61
8.2 Working depth of the levelling unit ........................................................................................ 62
8.2.1 Setting the working depth of the levelling unit mechanically ................................................. 62
8.2.2 Setting the working depth of the levelling unit hydraulically .................................................. 62
8.3 Adjusting the stripper............................................................................................................. 63
9 Transportation ........................................................................................... 64
10 Use of the machine ................................................................................... 65
10.1 Changing from transport to working position ........................................................................ 65
10.2 Operation ............................................................................................................................... 65
10.3 Headland ............................................................................................................................... 65
11 Faults .......................................................................................................... 66
12 Cleaning, maintenance and repairs ......................................................... 67
12.1 Cleaning ................................................................................................................................ 68
12.2 Lubrication instructions.......................................................................................................... 68
12.3 Maintenance plan - overview ................................................................................................ 70
12.4 Coulter replacement and tine replacement ........................................................................... 71
12.4.1 Tine replacement ................................................................................................................... 71
12.4.2 Coulter replacement .............................................................................................................. 72
12.4.3 Coulter replacement C-Mix-Clip ............................................................................................ 72
12.5 Installing and removing the disc segments (workshop work)................................................ 72
12.6 Replacing discs (workshop work) .......................................................................................... 73
12.7 Tine connection ..................................................................................................................... 73
12.8 Checking the roller ................................................................................................................ 74
12.9 Disc carrier connection .......................................................................................................... 74
12.10 Hydraulic system (workshop work) ....................................................................................... 75
12.10.1 Labelling hydraulic hose lines ............................................................................................... 76
12.10.2 Maintenance intervals ........................................................................................................... 76
12.10.3 Inspection criteria for hydraulic hose lines ............................................................................ 76
12.10.4 Installation and removal of hydraulic hose lines ................................................................... 77
12.11 Lower link pins ....................................................................................................................... 77
13 Hydraulic circuit diagram ......................................................................... 78
13.1 Screw tightening torques ....................................................................................................... 79
6
Cenius 03 BAG0144.5 10.19
To Next Page
Loading...
